Washer Spacers underneath valve lifters

[Co2]

lmao!
Thanks that cleared up a whole shit load of confusion. I'm assuming the guy who took the head apart put them there to not lose any of the washers... weird.

Anyhow I tried measuring them with the washers inside and was freakin out because there's no clearance whatsoever. However now that the washers out I now have clearance.

I've just measured the exhaust side and they're clearly too tight on some.

Also on a side note the exhaust cam is the one with the grooved teeth correct?

[Co2]

Ok I'm able to measure all my clearance. I've got all my exhaust, however when I try to measure my intake. about more than half seem to have no clearance what so ever. Please let me know if the exhaust seem to be in spec
Exhaust
1-0.28
2-0.27
3-0.32
4-0.22
5-0.30
6-0.37
7-0.26
8-0.24
9-0.28
10-0.27
11-0.23
12-0.23

[cre]

Originally Posted by Co2

Also on a side note the exhaust cam is the one with the grooved teeth correct?

Yes, the worm gear drive for the distributor.