what are all of these?
http://i536.photobucket.com/albums/f...m/photo3-2.jpg

http://i536.photobucket.com/albums/f...m/photo2-3.jpg

http://i536.photobucket.com/albums/f...um/photo-3.jpg

The plug is your reverse switch. and the other threaded hole on pass. Side by the tail piece is for the speedo

Idk if you have already decided to do whatever it is you were going to do. I think the easiest thing to do is to get the car up on four jack stands, makes things a lot simpler. Then get the jack under the tranny and take the bolts off and the couple connections and that's about it for taking it off.

Ooops maybe should have kept going through the post. Sorry I was a little late aha

so when i do the swap the speedo cable screws on and the reverse lights are the only to things i need for the swap? is there any other cables or plugs?

The additional room is very nice but this can be a lethal suggestion unless additional efforts are in place. I recommend placing the car's wheels or another different under the frame and floorboard if you don't have wheels to use then put each on top of two parallel pieces of 2x4. Try to get them tall enough to leave only and in or two of clearance on top.

i use cinder blocks :P

Other then bypassing the park switch that's it!

how do i bypass?
and when i do, do i still step on the clutch to start it?

Rims are less likely to tip.... or crumble. :P With out a lift I'm paranoid. ;)