I need to know the inner diameter of the 89-92 Turbos rear A arm bushing holes

Burn N' Up · 12-27-2010, 06:24 PM

The title pretty much said it. I'm going full poly on the rear A arms and trailing arm so i need to know the inner diameter on the bushing hole so i can get the right size bushings. Any help me out? Inches or metric, doesn't matter your measurement. THANKS!

907mge · 12-27-2010, 10:42 PM

Why not just buy the set?

http://store.driftmotion.com/static/i-83127g.php

12-27-2010, 06:24 PM	#1
Burn N' Up 3" Exhaust Join Date: Sep 2005 Posts: 238	I need to know the inner diameter of the 89-92 Turbos rear A arm bushing holes The title pretty much said it. I'm going full poly on the rear A arms and trailing arm so i need to know the inner diameter on the bushing hole so i can get the right size bushings. Any help me out? Inches or metric, doesn't matter your measurement. THANKS! __________________ 89Turbo 5 speed:Eibach lowered,Tokico Illumina II TEMS,All Poly Bushings,3" Elbow/DP/Cat,HKS Sport Turbo Exhaust,K&N FPIK w/ AEM Dryflow,Cooleeze ceramic coated Turbo inlet Pipe and 2.5" hard IC Pipes,Custom 2.5" fitting Spearco IC,HKS SSQV BOV,Greddy 1.5mm MHG and timing belt,Magnecore Comp Wires,NGK IR Low-temp Plugs,ARP studs,Dual Flex-a-lite fans w/ thermo switch,Fluidyne Rad,PCV VTA,Stage 3 F1 Racing clutch,Stainless braided clutch line and brake lines,Drilled & slotted rotors,EBC pads.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
1991 Supra - Water in Rear Wheel Wells	unkymurch	Non-Generation Specific Questions	7	03-02-2007 12:59 AM

12-27-2010, 10:42 PM	#2
907mge 20psi boost Join Date: Dec 2009 Location: Harrisburg Posts: 759	Why not just buy the set? http://store.driftmotion.com/static/i-83127g.php