Home / Toyota Supra Forums

Go Back   Toyota Supra Forums! Join the Supra forum! > Performance, Modification, and Maintenance Forums - for generation specific discussions > MKIII Supra

Reply
 
Thread Tools Display Modes
Old 08-30-2010, 08:37 PM   #1
Ranma
12psi boost
 
Ranma's Avatar
 
Join Date: Jun 2010
Location: Claremore, OK
Posts: 326
Blog Entries: 10
Ranma is an unknown quantity at this point
Talking

Bill UK, thank you for your information. I had the rear seals changed when the clutch was replaced by Toyota. They were also suppose to change the cam seals as well. Yes I suppose any engine leak will migrate to the rear of the engine. It is a good size leak and am annoyed that they did not fix it.
I would fix it myself but no longer even have a floor jack. Guess I need to give it the once over myself.
Thank you again for your useful information!
__________________
1986 Mk III MA70 7MGE Targa Top 5 Speed Stock Exhaust
Ranma is offline   Reply With Quote
Old 08-31-2010, 06:47 PM   #2
MA70 Owner
Stock
 
Join Date: May 2010
Location: Albuquerque
Posts: 5
MA70 Owner is on a distinguished road
Default rear main seal...

it most likely the rear main seal ive had the same problem. you said you replaced it put the truth is it probably wasnt done right i would try that first because its easy to access and the seal is fairly cheap.
MA70 Owner is offline   Reply With Quote
Old 08-31-2010, 07:03 PM   #3
Ranma
12psi boost
 
Ranma's Avatar
 
Join Date: Jun 2010
Location: Claremore, OK
Posts: 326
Blog Entries: 10
Ranma is an unknown quantity at this point
Talking

I let Riverside Toyota of Tulsa change the rear main seal when they changed the clutch. You would think the dealer would do a proper job. I know where not to buy my next new car. Suppose I could bring it by the competition dealer. The maintenance "adviser" said something about a seal on the backside of the engine leaking. He said this to me not long before getting sacked. What could he be talking about? He said the engine had to be removed to fix it.
__________________
1986 Mk III MA70 7MGE Targa Top 5 Speed Stock Exhaust
Ranma is offline   Reply With Quote
Old 08-31-2010, 08:39 PM   #4
Bill UK
AEM EMS
 
Bill UK's Avatar
 
Join Date: Jul 2006
Location: UK
Posts: 891
Bill UK is on a distinguished road
Default

No need to pull the engine to replace the rear crankshaft seal and gasket, especially in a fully equipped professional garage. Remove the gearbox clutch & flywheel and your there. Now if it was the sump (oil pan) leaking at the rear, then you need to lift the engine or remove the front sub frame to drop the sump.
Bill UK is offline   Reply With Quote
Old 08-31-2010, 09:52 PM   #5
Bill UK
AEM EMS
 
Bill UK's Avatar
 
Join Date: Jul 2006
Location: UK
Posts: 891
Bill UK is on a distinguished road
Default

There you go ! all the likely places where an oil leak could accrue; I’ve marked the oil gallery plug only for reference, its very unlikely this would leak.

Bill UK is offline   Reply With Quote
Old 08-31-2010, 10:03 PM   #6
Ranma
12psi boost
 
Ranma's Avatar
 
Join Date: Jun 2010
Location: Claremore, OK
Posts: 326
Blog Entries: 10
Ranma is an unknown quantity at this point
Talking the dealer messed up

Got a chance to look under her at the wheel shop. She is leaking from the rear main, the oil pan, the oil plug. Talking with the owner of the shop he thinks the main bearings may be bad. This would cause the seals to leak.
My gripe is they were suppose to repair these items. You would think the Toyota dealer would do a proper job. Well gotta run, school tonight a biology exam
__________________
1986 Mk III MA70 7MGE Targa Top 5 Speed Stock Exhaust
Ranma is offline   Reply With Quote
Old 09-01-2010, 02:15 AM   #7
Green7mgte
Supra Forum Moderator
 
Join Date: Nov 2009
Location: Green-Ohio
Posts: 1,297
Green7mgte is on a distinguished road
Default

sounds like someone is entitled to a free repair.
__________________

92 Ma71 7mGTE Auto. SafcII
Supra FAQ
Supra MKIII FAQ
Classified Section guidelines :

Green7mgte is offline   Reply With Quote
Old 09-01-2010, 04:02 PM   #8
Ranma
12psi boost
 
Ranma's Avatar
 
Join Date: Jun 2010
Location: Claremore, OK
Posts: 326
Blog Entries: 10
Ranma is an unknown quantity at this point
Talking

Talked to the General Manager of the dealer. He was unable/unwilling to help. He is passing this off to the service manager or the person I have been dealing with on this problem. If I felt better would do the work myself. Could a worn out bearing cause the seal to leak? My thing in life is aircraft structural repair and not piston engines. Even that has been some time ago, the Corps has me warming an office chair now
__________________
1986 Mk III MA70 7MGE Targa Top 5 Speed Stock Exhaust
Ranma is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Putting JDM engine in!!! :D dannydavi MKIII Supra 24 11-02-2009 06:30 AM
rebuilt hard to crank (high engine resistance); need advice cbrewster MKIII Supra 4 09-28-2009 04:52 PM
problem seperating engine from manual tranny Gengus MKIII Supra 7 01-29-2008 12:10 AM


All times are GMT. The time now is 09:22 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.

1986



1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87