87 non turbo wont start, need some advice...please.

HotRodV6 · 09-02-2010, 01:28 AM

Ok, well after checking everything and replacig what checked bad, i ran out of options and replaced the ignitor/control module and the car still wont start, and has no spark, its getting fuel. Im at a loss with this thing, everything ive checked per the TSRM is good or been replaced, i took the oil fil cap off and the cam is turning like it should so im pretty sure its not a timing belt issue. Any other ideas or help you wish to give would be really appreciated.

Green7mgte · 09-02-2010, 02:25 AM

clutch start switch?

shrugs..

car needs 3 things to start.. spark, fuel , compression.

you pulled a plug and had a buddy crank the engine to see if it sparked? or something along those lines of troubleshooting?
you checked the wires
ignition and your diz.

as for fuel you said you changed out your pump and are getting good readings across the board.

what about compression. if your getting crank it might not be electrical.
hows your fuel pressure?

did you say you replaced the starter? or checked it?. run it down to your local auto parts store and have them test it. or shit just buy a new solenoid. there about 17 bucks. see what that does for you.

in the mean time re read No start EFI troubleshooting

good luck.

http://www.aa1car.com/library/car_wont_start.htm

above link is just a general search page. good info tho.

Vacationtime247 · 09-02-2010, 07:29 AM

Sounds like the ignition isn't getting a signal to fire. If your getting fuel, then it's spark related. ECU not sending a signal to the module telling it to fire? Kind of a shot in the dark. But this is where I'd check. Check + voltage in at the module.
VT247

Quote:

Originally Posted by HotRodV6

Ok, well after checking everything and replacig what checked bad, i ran out of options and replaced the ignitor/control module and the car still wont start, and has no spark, its getting fuel. Im at a loss with this thing, everything ive checked per the TSRM is good or been replaced, i took the oil fil cap off and the cam is turning like it should so im pretty sure its not a timing belt issue. Any other ideas or help you wish to give would be really appreciated.

09-02-2010, 02:25 AM	#2
Green7mgte Supra Forum Moderator Join Date: Nov 2009 Location: Green-Ohio Posts: 1,297	clutch start switch? shrugs.. car needs 3 things to start.. spark, fuel , compression. you pulled a plug and had a buddy crank the engine to see if it sparked? or something along those lines of troubleshooting? you checked the wires ignition and your diz. as for fuel you said you changed out your pump and are getting good readings across the board. what about compression. if your getting crank it might not be electrical. hows your fuel pressure? did you say you replaced the starter? or checked it?. run it down to your local auto parts store and have them test it. or shit just buy a new solenoid. there about 17 bucks. see what that does for you. in the mean time re read No start EFI troubleshooting good luck. http://www.aa1car.com/library/car_wont_start.htm above link is just a general search page. good info tho. __________________ 92 Ma71 7mGTE Auto. SafcII Supra FAQ Supra MKIII FAQ Classified Section guidelines : Last edited by Green7mgte; 09-02-2010 at 02:28 AM.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
changed turbo and now the car wont start	venomstreetmachine	MKIII Supra	12	08-26-2009 12:45 AM
HELP PLEASE	Nick0887	Non-Generation Specific Questions	4	02-28-2009 07:26 AM
Turbo Advice	White_on_black	MKIII Supra	2	01-28-2008 04:43 AM
Dream Offer	Karma_Supra	MKIV Supra	22	10-17-2007 03:04 PM
Sequential Turbo Question	suprapoweredsoarer	MKIV Supra	1	06-06-2006 12:13 AM

09-02-2010, 01:28 AM	#1
HotRodV6 Stock Join Date: Aug 2010 Location: Huntsville, Tx. Posts: 2	Ok, well after checking everything and replacig what checked bad, i ran out of options and replaced the ignitor/control module and the car still wont start, and has no spark, its getting fuel. Im at a loss with this thing, everything ive checked per the TSRM is good or been replaced, i took the oil fil cap off and the cam is turning like it should so im pretty sure its not a timing belt issue. Any other ideas or help you wish to give would be really appreciated.