08-23-2010, 06:27 PM
|
#1 |
|
3" Exhaust
Join Date: Nov 2009
Location: Santa Fe, NM
Posts: 135
 |
machining mistake
So I was reading up some build threads today and saw that when the block was being machined it has to have the timing belt cover on it because the head actually rests on it. I didn't have this done and now I feel like an idiot.... I think so lol. What can or should I do now. The block had 0.013" taken off so there is a 0.013" difference between the block and the timing belt cover. I need to know what I should do
Thank you
__________________
Cusco front, Tein Rear coilovers Massive DDP, 3'' custom catless exhaust, Tsudo muffler 4.5'' outlet, Apexi cold air intake, Act stage 3 clutch, ct26 turbo (stock)- 10psi +300rwhp "Not driving a car because its too nice, is like not fucking your gf so shes still tight for the next guy" |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aluminium piping. Is it a mistake or not? | azerty | MKIII Supra | 13 | 04-30-2008 08:33 PM |
Threaded Mode