|
![]() |
#1 |
3" Exhaust
Join Date: Apr 2010
Location: sarasota fl
Posts: 194
![]() |
![]()
if the car is filling the overfill on its own then it got hot or your radiator cap is too weak..
as for the lope, it takes alot to get a noticable lope out of these cars when i first got mine both of my cams were off by a tooth advanced on the intake retarded on the exhaust and it loped but not too much its gonna be a fuel or ignition problem check your fuel pressure with and without the regulator it should raise about 10 psi +- a little without the regulator hooked up check your timing under light load just give it a little throttle and see where it goes it might be your wires sounds like what your getting is a miss not a lope but idk... is it more of a shake? my car shakes at 2k just about every gear doesnt matter with throttle or anything but it is more noticable at cruising or light throttle and nothing is actually wrong with it it just does it ...
__________________
92 miata 7mgte swap ![]() Last edited by turbonicsperformance; 06-08-2010 at 02:52 AM. |
![]() |
![]() |
![]() |
#2 |
12psi boost
Join Date: May 2010
Location: West Virginia
Posts: 320
![]() |
![]()
I called a friend of mine and he said it could be dirty injectors. I am unsure if I should call it surging or loping. It's like when you are going it starts to rock you forward and back like it surges and then lets go on a very rythmic basis. Not there in hard acceleration or gear downs just as you are under light to medium load. Seems to get worse as the car warms up.
I sucked a lot of stuff through the throttle body cause of a rats nest in the air cleaner. When it happens it rocks you like your in a rocker forward and back it's annoying as hell. Its not so much a miss as like you are pushing on the gas lightly and then off and then on and then off about once every half second. My cams are dead on cause I just did the timing belt. Where is the fuel regulator you speak of? Thanks, Scott
__________________
1987 N/A 7MGE Left Hand Drive MK3 Red 5 Speed and Black Auto Supras My Next project is the Batmobile! Last edited by batmmannn; 06-08-2010 at 04:51 AM. |
![]() |
![]() |
![]() |
#3 |
Super Moderator
Join Date: May 2007
Location: Billings, Montana
Posts: 1,034
![]() |
![]()
Have you checked for codes yet? Keep in mind that not all codes will cause the CEL to stay on. To me it almost sounds like a bad connection to the TPS (which 2 of my 3 supra's have had thanks to the lack of that metal clip on the electrical connector). Anyway, check the codes!
__________________
1989 7MGTE R154 Targa Top White Package w/Blue Interior Driftmotion 57trim CT26, Upgraded Intercooler, 2.25" Hard Pipes, 3" Turbo Back Exhaust with Test Pipe, HKS VPC w/GM 3 bar MAP sensor, APEXi S-AFC, Walbro 255lph fuel pump, ProSport EVO Series Boost / Fuel Pressure / AFR gauges, Lotek a Pillar Gauge Pod, HKS Type 0 Turbo Timer, Eibach Lowering Springs, Tokico Illumina II TEMS struts, custom powder coated Motegi Racing TrakLite wheels |
![]() |
![]() |
![]() |
#4 |
12psi boost
Join Date: May 2010
Location: West Virginia
Posts: 320
![]() |
![]()
Neither of my Supras have metal clips on the TPS connector. Here is a pic of what I have. I suppose I can get this clip from the Dealer if it is missing? Or is it inside the connector? I see something metal there. Thanks, Scott
__________________
1987 N/A 7MGE Left Hand Drive MK3 Red 5 Speed and Black Auto Supras My Next project is the Batmobile! |
![]() |
![]() |
![]() |
#5 |
Super Moderator
Join Date: May 2007
Location: Billings, Montana
Posts: 1,034
![]() |
![]()
The metal clip (it looks like a paperclip) goes on the outside of the TPS connector. There's a little groove cut in the connector towards the end of it (furthest from the wires) that is slips onto, which helps lock it in place on the TPS. Without it, the connector can vibrate loose giving the ECU intermittent readings from the TPS.
__________________
1989 7MGTE R154 Targa Top White Package w/Blue Interior Driftmotion 57trim CT26, Upgraded Intercooler, 2.25" Hard Pipes, 3" Turbo Back Exhaust with Test Pipe, HKS VPC w/GM 3 bar MAP sensor, APEXi S-AFC, Walbro 255lph fuel pump, ProSport EVO Series Boost / Fuel Pressure / AFR gauges, Lotek a Pillar Gauge Pod, HKS Type 0 Turbo Timer, Eibach Lowering Springs, Tokico Illumina II TEMS struts, custom powder coated Motegi Racing TrakLite wheels |
![]() |
![]() |
![]() |
#6 |
12psi boost
Join Date: May 2010
Location: West Virginia
Posts: 320
![]() |
![]()
Well I guess I need o get a couple of those. One for each car. Obviously I am missing that clip on both cars if it isn't showing in that pic. I'll stop at the dealer tomorrow and see if they are available. Thanks!
__________________
1987 N/A 7MGE Left Hand Drive MK3 Red 5 Speed and Black Auto Supras My Next project is the Batmobile! |
![]() |
![]() |
![]() |
#7 |
20psi boost
Join Date: Dec 2009
Location: Harrisburg
Posts: 759
![]() |
![]()
That plug is attached to the wiring harness. So without buying a whole harness, you probably can't get the plug. The best place is probably the junk yard for parts like that. Good luck getting just the clips. On my car I have a few plugs that are broken but never fall off.
|
![]() |
![]() |
![]() |
#8 |
12psi boost
Join Date: May 2010
Location: West Virginia
Posts: 320
![]() |
![]()
Well my plug is fine all I need is the clip. Can anyone post a pic of the connector with the clip on? Thanks, Scott
__________________
1987 N/A 7MGE Left Hand Drive MK3 Red 5 Speed and Black Auto Supras My Next project is the Batmobile! |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
vibrations under load | mike_j_2me | MKIII Supra | 3 | 11-16-2007 05:21 PM |
stalling under load | marxdenning | Non-Generation Specific Questions | 1 | 01-18-2007 09:51 PM |