05-25-2010, 05:12 AM
|
#8 |
|
12psi boost
Join Date: May 2010
Location: West Virginia
Posts: 320
 |
2 seals!
Hey that drawing looks like it slightly smaller and thick. I bet that is it. I should use it then. Thanks Jim! Scott
ooops just ran the part number came back as Crankshaft front oil seal 90080-31022. Strange it's a crank seal but does not fit nor go on my car that I can see. maybe it crosses over to the oil pump seal. I will have to check with the dealer. My oil pump seal appears to be fine though. Updated! OK Mystery solved. The extra seal in the Felpro pack is the oil pump seal. Not gonna replace it cause it is not leaking. Not Broke? Leave it alone! The guys at the Toyota dealership sold me an oil pump seal knowing I needed a crank seal go figure! Evidently the oil pump seal on our cars also fit other cars as the crank seal.....
__________________
1987 N/A 7MGE Left Hand Drive MK3 Red 5 Speed and Black Auto Supras My Next project is the Batmobile! Last edited by batmmannn; 05-25-2010 at 11:38 PM. |
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A Little Story about a crank bolt | abhattan | MKIII Supra | 17 | 03-28-2013 01:06 AM |
| Crank Pulley | btwilson86 | MKIII Supra | 10 | 05-22-2010 03:30 AM |
| rebuilt hard to crank (high engine resistance); need advice | cbrewster | MKIII Supra | 4 | 09-28-2009 04:52 PM |
| Front Main Seals | nickvash0104 | MKIII Supra | 5 | 01-08-2006 06:48 AM |
| Valve Stem Oil Seals | Roger UK | MKIII Supra | 1 | 10-17-2005 01:24 PM |
Threaded Mode