7mgte issues need help doing diag

touge_monster86 · 03-12-2010, 05:52 AM

FIXED IT!!!! lol

im dumb when i wired the igniter to the coil packs i miss matched a wire. and this yellow wire that goes to the egniter was barely attached to the plug lol

im an idiot .

so it start and runs pritty damn good but it has a tuff time starting and when i push the throttle it bogs a bit on the way up . i would say that it smooths out and climes nice and strong after about 3,000 rpm.

its almost as if it has a bad cold start or and its getting a bad o2 reading on eccelaration .......idk . would it have anything to do with the fact that its running of the manifold and down pipe ?

you have any idias ?

btwilson86 · 03-12-2010, 07:58 AM

Since it can now run longer than 5 seconds, before anything else I'd check your ignition timing. You're almost guaranteed to be off a little, and that could be what's causing the hard start and boggy acceleration (it only takes being a couple of degrees off to run like crap)

touge_monster86 · 03-12-2010, 05:16 PM

I checked the timing a few times allready thinking it was that to begin with. It's dialed in. Once it warms up it runs to smooth for it to be out of calabration . I can check it again but I'm possitive that every thing is were it should be in reagards to timing

03-12-2010, 07:58 AM	#2
btwilson86 Super Moderator Join Date: May 2007 Location: Billings, Montana Posts: 1,034	Since it can now run longer than 5 seconds, before anything else I'd check your ignition timing. You're almost guaranteed to be off a little, and that could be what's causing the hard start and boggy acceleration (it only takes being a couple of degrees off to run like crap) __________________ 1989 7MGTE R154 Targa Top White Package w/Blue Interior Driftmotion 57trim CT26, Upgraded Intercooler, 2.25" Hard Pipes, 3" Turbo Back Exhaust with Test Pipe, HKS VPC w/GM 3 bar MAP sensor, APEXi S-AFC, Walbro 255lph fuel pump, ProSport EVO Series Boost / Fuel Pressure / AFR gauges, Lotek a Pillar Gauge Pod, HKS Type 0 Turbo Timer, Eibach Lowering Springs, Tokico Illumina II TEMS struts, custom powder coated Motegi Racing TrakLite wheels

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
7MGTE to 7MGE	karu	MKIII Supra	4	10-22-2010 07:22 AM
7MGTE Wiring Harness Issues	JMoses	MKIII Supra	12	06-03-2009 01:56 PM
JDM 7mgte help	98fxdwg	Non-Generation Specific Questions	0	10-30-2007 05:45 AM
7mgte and 7mge question	supraman121	MKIII Supra	2	01-12-2007 09:09 PM

03-12-2010, 05:52 AM	#1
touge_monster86 Stock Join Date: Mar 2010 Location: huntington beach Posts: 11	FIXED IT!!!! lol im dumb when i wired the igniter to the coil packs i miss matched a wire. and this yellow wire that goes to the egniter was barely attached to the plug lol im an idiot . so it start and runs pritty damn good but it has a tuff time starting and when i push the throttle it bogs a bit on the way up . i would say that it smooths out and climes nice and strong after about 3,000 rpm. its almost as if it has a bad cold start or and its getting a bad o2 reading on eccelaration .......idk . would it have anything to do with the fact that its running of the manifold and down pipe ? you have any idias ?

03-12-2010, 05:16 PM	#3
touge_monster86 Stock Join Date: Mar 2010 Location: huntington beach Posts: 11	I checked the timing a few times allready thinking it was that to begin with. It's dialed in. Once it warms up it runs to smooth for it to be out of calabration . I can check it again but I'm possitive that every thing is were it should be in reagards to timing