safc1 installation

cre · 02-06-2010, 01:13 AM

Already covered that... you just need a signal from IGt. Look it up in the TSRM (EFI section).

cre · 02-06-2010, 01:59 AM

Do you have a wideband and gauge installed? If not don't make ANY changes until you get one installed or can have a shop tune it.

IGf is only really needed with ignition control systems.

cre · 02-06-2010, 02:45 AM

Quote:

Originally Posted by Green7mgte

the safc allows you to monitor to an extent and adjust the value.

It may allow you to see what airflow signal the ECU is getting from the meter, but it doesn't tell you at all how much fuel the ECU is actually delivering or how your changes are affecting it. You could always monitor the Vf feedback, but it's pointless in any setup that's remotely close to stock as it only provides feedback for closed loop operations and under certain rare conditions at WOT.

Portable wideband is the way to go as it allows on-the-go tuning. Get it close and dyno for for fine tuning if needed thereafter.

cre · 02-06-2010, 03:02 AM

Just leave all the adjustments at "0" and you're fine.

Green7mgte · 02-06-2010, 03:10 AM

here is the pin for the ecu. and the wire diagram for Karman engines such as ours.

Green7mgte · 02-07-2010, 12:09 AM

man I spent about 3 hours out there today. hooked everything up according to the print out and blah, nothing on start up and I had the all clear code flashing on my dash. maybe something wasn't connected as securely as it should of been. idk. but now im a little sad. cold and hungry. oh and my dash is still torn apart and I have to work at 6am tomorrow.
im including this link
http://www.snapdrive.net/files/91304...SAFR_MKIII.pdf
more informative then the others above.

cre · 02-07-2010, 05:06 AM

You do still have to setup the SAFC's system for the 7M-GTE... you just don't touch any of the tuning specific settings.

02-06-2010, 01:13 AM	#1
cre Toyota Racing Development Join Date: Apr 2007 Posts: 5,038	Already covered that... you just need a signal from IGt. Look it up in the TSRM (EFI section). __________________ If something breaks or you need to contact a member of the administration please post HERE. Unless it's a private or administration matter please post it on the forum. It benefits no one else if car related questions aren't posted for future users and takes away from the time I'm able to spend helping on the rest of the forum. If you're so inclined I'm always more than happy to accept tips via PayPal. Tip Jar --->

02-06-2010, 01:59 AM	#2
cre Toyota Racing Development Join Date: Apr 2007 Posts: 5,038	Do you have a wideband and gauge installed? If not don't make ANY changes until you get one installed or can have a shop tune it. IGf is only really needed with ignition control systems. __________________ If something breaks or you need to contact a member of the administration please post HERE. Unless it's a private or administration matter please post it on the forum. It benefits no one else if car related questions aren't posted for future users and takes away from the time I'm able to spend helping on the rest of the forum. If you're so inclined I'm always more than happy to accept tips via PayPal. Tip Jar --->

02-06-2010, 03:02 AM	#4
cre Toyota Racing Development Join Date: Apr 2007 Posts: 5,038	Just leave all the adjustments at "0" and you're fine. __________________ If something breaks or you need to contact a member of the administration please post HERE. Unless it's a private or administration matter please post it on the forum. It benefits no one else if car related questions aren't posted for future users and takes away from the time I'm able to spend helping on the rest of the forum. If you're so inclined I'm always more than happy to accept tips via PayPal. Tip Jar --->

02-06-2010, 03:10 AM	#5
Green7mgte Supra Forum Moderator Join Date: Nov 2009 Location: Green-Ohio Posts: 1,297	here is the pin for the ecu. and the wire diagram for Karman engines such as ours. Attached Thumbnails

02-07-2010, 12:09 AM	#6
Green7mgte Supra Forum Moderator Join Date: Nov 2009 Location: Green-Ohio Posts: 1,297	man I spent about 3 hours out there today. hooked everything up according to the print out and blah, nothing on start up and I had the all clear code flashing on my dash. maybe something wasn't connected as securely as it should of been. idk. but now im a little sad. cold and hungry. oh and my dash is still torn apart and I have to work at 6am tomorrow. im including this link http://www.snapdrive.net/files/91304...SAFR_MKIII.pdf more informative then the others above. __________________ 92 Ma71 7mGTE Auto. SafcII Supra FAQ Supra MKIII FAQ Classified Section guidelines :

02-07-2010, 05:06 AM	#7
cre Toyota Racing Development Join Date: Apr 2007 Posts: 5,038	You do still have to setup the SAFC's system for the 7M-GTE... you just don't touch any of the tuning specific settings. __________________ If something breaks or you need to contact a member of the administration please post HERE. Unless it's a private or administration matter please post it on the forum. It benefits no one else if car related questions aren't posted for future users and takes away from the time I'm able to spend helping on the rest of the forum. If you're so inclined I'm always more than happy to accept tips via PayPal. Tip Jar --->

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Question regarding a DVD installation	Grandavi	MKIII Supra	0	08-12-2009 01:39 AM
K&N FIPK installation guid with pics	azerty	MKIII Supra	1	05-04-2008 02:12 PM
Speaker Panels Installation, HELP	minusthecoop	MKIII Supra	0	04-13-2008 09:43 PM
Alternator belt removal and installation!	~B Magical~	MKIII Supra	11	03-13-2008 07:27 PM
wideband o2 installation	Burning Pyro	MKIII Supra	1	08-29-2007 11:34 PM