12-21-2009, 03:16 AM
|
#1 |
|
Stock
Join Date: Dec 2009
Location: new york
Posts: 1
 |
1jz engine swapp
im going to be swapping a 1jz with a 5 speed into my car im not gonna say what it is because i will get slapped but how hard is it to swap and what am i gonna need if the car is originally carbed?
|
|
|
|
12-21-2009, 03:55 AM
|
#2 |
 Toyota Racing Development Join Date: Apr 2007
Posts: 5,038
 |
I've seen a 2JZ in an OLD Subaru station wagon... you'll be getting no slappage here.
 As far as what you'lll need... well, I'd look for a complete front clip myself. You'll need at a minimum: long block, intake manifold and plenum, throttle body, intercooler piping, intercooler, turbos, blow off valve, exhaust manifold and down pipe, ECU, engine harness, dash harness, fuse box, igniter, coils, an electric fuel pump that is made for EFI systems... all the usual stuff really. I can't think of anything else i'm missing at the moment. I'm sure someone else will chime in if there's something to be added to the list though.
__________________
If something breaks or you need to contact a member of the administration please post HERE. Unless it's a private or administration matter please post it on the forum. It benefits no one else if car related questions aren't posted for future users and takes away from the time I'm able to spend helping on the rest of the forum. If you're so inclined I'm always more than happy to accept tips via PayPal.  Tip Jar --->  |
|
|
|
|
12-22-2009, 02:39 AM
|
#3 |
|
3" Exhaust
Join Date: May 2008
Location: Sacramento
Posts: 60
|
Also, think about an electric fan and fan controller, and 2jz water pump and pully kit. The 1jz normally uses a hydraulic fan set up, and unless you can get all the parts for it and set it up to work properly (good luck), it'll probably burn through the water pump and you'll have to get a 2j pump anyway. The 1j water pump has an integrated hydraulic pump for the fan, so with no hydro fluid running in there bearings will eventually burn out, and you'll need a new water pump anyway.
Like to know what you're swapping it into though, it's always nice to hear someone's ideas.
__________________
1jz-gte swap (Currently spun #3 rod bearings), Apexi high flow filter, Greddy thrust 3" downpipe, N1 3" catback with cat delete tube, 1 peice driveshaft, Bar and Plate intercooler, and 440 JDM 2jz injectors. Possible 2jz lower block swap in the works if I can't rebuild the 1j. So troublesome. |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rebuilt hard to crank (high engine resistance); need advice | cbrewster | MKIII Supra | 4 | 09-28-2009 04:52 PM |
| problem seperating engine from manual tranny | Gengus | MKIII Supra | 7 | 01-29-2008 12:10 AM |
| engine swapp | hotrodfabian | Non-Generation Specific Questions | 1 | 09-03-2007 08:27 PM |
| Keeping Engine Cool | mrnickleye | Supra FAQ | 0 | 06-04-2005 10:02 PM |
Linear Mode
