01-21-2010, 07:01 AM
|
#11 | |
 Toyota Racing Development Join Date: Apr 2007
Posts: 5,038
  |
Think about it, an even smaller O-Ring hold the fuel in the rail where the injectors connect... besides, I suspect the threads (when properly torqued) hold back most of the pressure. The FPR doesn't use a tapered thread (at least not from what I recall) so there's no worry about you having spread the opening too far... if it is tapered and the o-ring doesn't provide the seal, you may indeed be looking for a new fuel rail... But, I don't think that's the case at all.
Quote:
      <----- All applicable.
__________________
If something breaks or you need to contact a member of the administration please post HERE. Unless it's a private or administration matter please post it on the forum. It benefits no one else if car related questions aren't posted for future users and takes away from the time I'm able to spend helping on the rest of the forum. If you're so inclined I'm always more than happy to accept tips via PayPal.  Tip Jar --->  |
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lower Ball Joints - Checking here first | Grandavi | MKIII Supra | 3 | 09-20-2008 04:04 AM |
| Picking up my 89 tomorrow | 8uwav6 | Show n Tell | 2 | 03-31-2008 08:08 PM |
| Checking Thermostat | scruffboy | Non-Generation Specific Questions | 6 | 03-09-2006 05:49 PM |
| Supra Noob checking in from Florida | PalmCoastMk3 | Non-Generation Specific Questions | 1 | 12-23-2005 05:08 PM |
| Supra Newb Just checking in | Razor | Non-Generation Specific Questions | 1 | 12-21-2005 04:15 AM |
Threaded Mode