Pressure Hose on Power Steering, first Supra and first post here.

Chambers · 11-30-2008, 10:43 PM

The best way would be jack it up and put jack stands in the correct places on either side of the car. After that I think you will need a few large wrenches, I think anywhere between 17mm and 21mm, I can't remember exactly. Also a 10mm socket to remove a bracket for the lines.

If you got the hose from Driftmotion, then you will have to wrestle it a little to get it to work, but I will fit fine, may be good to have a friend help.

Also make sure to refill the reservoir with Dextron II or III auto tranny fluid when finished.

Good luck.

11-30-2008, 10:43 PM	#2
Chambers walbro fp Join Date: May 2007 Location: USA - Harford County, Maryland Posts: 481	The best way would be jack it up and put jack stands in the correct places on either side of the car. After that I think you will need a few large wrenches, I think anywhere between 17mm and 21mm, I can't remember exactly. Also a 10mm socket to remove a bracket for the lines. If you got the hose from Driftmotion, then you will have to wrestle it a little to get it to work, but I will fit fine, may be good to have a friend help. Also make sure to refill the reservoir with Dextron II or III auto tranny fluid when finished. Good luck. __________________ Whats in the garage, well.... in the yard. 1986.5 Toyota Supra - NA - 5 spd 1986 Ford Ranger Lowrider - 5 spd 1984 Ford Ranger XLT - 7" Lift - 4X4 - Auto "Stuck in the 80's"

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode