its new 2 me

[supravan]

i have some1 2 weld it back 2gether 4 me so got that covered, now im wondering what if anything i wood have 2 change on the 1JZ?

[Chambers]

If you have the capacity to weld then it may be easier and cheaper to just make a front facing intake manifold, with a larger throttle body.

If not then modify your current intake manifold to a front facing status, as in cut open the front side of it, then weld the old TB hole up and put a new flange on the front side of the manifold, that way you retain all your stock engine parts but have the front facing intake.

Good luck.

[supravan]

if u have an idea of what i wood need 2 build a new 1 plz share the info or point me n the right direction. also its goin 2 b a cover vehicle so it has 2 look super clean i have a guy thats goin 2 make me a brand new harness and wire the motor up 4 me so all i got left is the intake manifold issue and the clutch pedal issue, since a van is auto and my trans is 5 speed anyways thanks 4 ur help

[Chambers]

Well you will need some aluminum tubes and sheets, I have a quick SolidWorks 3D rendering of one, its by no means to scale I just threw it together. The red lines in the first pic are where
the welds would be for the tube and sheets.





Here is an example of a FFIM using the stock lower intake manifold on someones car.

[supravan]

thanks alot and where u find that picture at i wood like 2 get ahold of that person and ask him question about his intake manifold

[shiftysupra]

chambers your awesome. gonna go buy the tubing to make one :] pics soon

[supravan]

chambers if u made 1 the way i needed it how much wood you charge? your best guess. and just let me know at my email danielwhly@yahoo.com and then i could send u pics of what i have done so far and u could get an idea of how much room i have 2 work with and thanks again for your help