![]() |
#1 |
3" Exhaust
Join Date: May 2008
Location: Gaithersburg, Maryland
Posts: 63
![]() |
![]()
ok so i adjusted my BOV so that I don't stall when i depress the clutch but now the engine makes a pretty bad clicking noise when i step on the gas. any ideas what's going on?
__________________
1991 Supra - Turbo - 5spd 60-1 upgraded turbo Lexus AFM 3" exhaust, 4" tip SAFC 2 550cc injectors (2 sets, venom direct fit, RC engineering) 2.5" intercooler and piping Aluminum radiator w/dual electric fans ARP bolts w/MHG Full-auto turbo timer Fidanza Flywheel & Stage 2 Clutch spark plugs and wires. power steering pump cold temp start switch engine top end rebuilt transmission opened up and inspected at a tranny shop when the flywheel and clutch installed last week. |
![]() |
![]() |
![]() |
#2 |
walbro fp
Join Date: May 2007
Location: USA - Harford County, Maryland
Posts: 481
![]() |
![]()
Does the sound have a plastic clicking sound to it? If so, it may be possible that something is hitting the fan.
Good luck. |
![]() |
![]() |
![]() |
#3 |
3" Exhaust
Join Date: May 2008
Location: Gaithersburg, Maryland
Posts: 63
![]() |
![]()
no it was a metal clicking coming from the engine. turns out that my head gasket lasted even less time than i expected it would with the upgraded turbo.
stock head gasket and a 60-1 turbo don't mix, which i already knew. i was just trying to hold out for a few months. stupid me. anyway the clicking was the result of the coolant washing away the oil, in other words metal to metal, no lubrication. so i'm off to install a MHG with ARP studs.
__________________
1991 Supra - Turbo - 5spd 60-1 upgraded turbo Lexus AFM 3" exhaust, 4" tip SAFC 2 550cc injectors (2 sets, venom direct fit, RC engineering) 2.5" intercooler and piping Aluminum radiator w/dual electric fans ARP bolts w/MHG Full-auto turbo timer Fidanza Flywheel & Stage 2 Clutch spark plugs and wires. power steering pump cold temp start switch engine top end rebuilt transmission opened up and inspected at a tranny shop when the flywheel and clutch installed last week. |
![]() |
![]() |
![]() |
#4 |
walbro fp
Join Date: May 2007
Location: USA - Harford County, Maryland
Posts: 481
![]() |
![]()
Ohh geeze, make sure you check your bearings, the lack of oil may have damaged them.
Good luck. |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Damn idle! | SCRAMJET | MKIII Supra | 10 | 02-19-2009 01:45 PM |
Choking and stall on startup | Durandal | MKIV Supra | 4 | 09-24-2008 10:32 PM |
High stall torque converter | southernsupra1 | MKIII Supra | 1 | 07-09-2006 11:24 PM |