head bolts tool

Serge · 07-18-2008, 06:25 AM

Guys,

What socket do I have to use with ARP bolts? My current 14 doesn't hold more than 60ft/lbs.Maybe I need better quality socket....
Thank you!

Bill UK · 07-18-2008, 07:14 PM

ARP studs/bolts are made in the US, I think your find they are imperial (inch) use a 9/16 long reach socket with a 3/8 drive, if your torque wrench is 1/2 use an adaptor. Thread size is 12 mm x 1.25 just in case you need to clean out the holes in the bock, which I recommend you do.

Serge · 07-19-2008, 05:30 AM

Thanks Bill. It's done now with 90ft/lbs.
I have a next question. How properly to clean the cold start injector? It's dirty and I would like to clean it up.

Serge · 07-22-2008, 06:34 AM

Okay,
The engine is working already...Do I have to replace catalutic after the running of this supra with blown gasket? How would I figure it out? (mileage 111000miles)
Thank you!

07-18-2008, 06:25 AM	#1
Serge 3" Exhaust Join Date: Mar 2008 Location: WA Posts: 69	Guys, What socket do I have to use with ARP bolts? My current 14 doesn't hold more than 60ft/lbs.Maybe I need better quality socket.... Thank you! Attached Thumbnails Last edited by Serge; 07-18-2008 at 07:00 AM.

07-19-2008, 05:30 AM	#3
Serge 3" Exhaust Join Date: Mar 2008 Location: WA Posts: 69	Thanks Bill. It's done now with 90ft/lbs. I have a next question. How properly to clean the cold start injector? It's dirty and I would like to clean it up. Attached Thumbnails

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
head bolts on jdm engine	tone loc	MKIII Supra	10	06-03-2007 09:33 PM
Head bolts	G-string	MKIII Supra	16	05-22-2007 04:22 PM
head gasket bolts	marc	MKIII Supra	6	10-23-2006 07:23 PM
Head Bolts, Or Head Studs??	ZauggIt1	MKIII Supra	2	08-08-2006 01:23 PM
ARP head bolts	Deputy99	MKIII Supra	2	07-19-2006 11:16 PM

07-18-2008, 07:14 PM	#2
Bill UK AEM EMS Join Date: Jul 2006 Location: UK Posts: 891	ARP studs/bolts are made in the US, I think your find they are imperial (inch) use a 9/16 long reach socket with a 3/8 drive, if your torque wrench is 1/2 use an adaptor. Thread size is 12 mm x 1.25 just in case you need to clean out the holes in the bock, which I recommend you do.

07-22-2008, 06:34 AM	#4
Serge 3" Exhaust Join Date: Mar 2008 Location: WA Posts: 69	Okay, The engine is working already...Do I have to replace catalutic after the running of this supra with blown gasket? How would I figure it out? (mileage 111000miles) Thank you!