Home / Toyota Supra Forums

Go Back   Toyota Supra Forums! Join the Supra forum! > Search Forums

Showing results 376 to 400 of 455
Search took 0.08 seconds; generated 39 minute(s) ago.
Search: Posts Made By: 87hilux7mge
Forum: MKIII Supra 04-26-2011, 06:20 AM
Replies: 11
Views: 15,490
Posted By 87hilux7mge
just go for about a 1.5 lower. its not so low...

just go for about a 1.5 lower. its not so low that you scrape every leaf on the road, but it looks good and it lowers the center of gravity and firms up the handling a decent amount. and as far as...
Forum: MKIII Supra 04-26-2011, 03:49 AM
Replies: 2
Views: 2,569
Posted By 87hilux7mge
reciprocating saw, sawzall and a grinder with a...

reciprocating saw, sawzall and a grinder with a cut off wheel. should be easy to cut up. prolly weighs 1500 lbs? idk maybe someone else can touch on this.
Forum: MKIII Supra 04-26-2011, 02:44 AM
Replies: 11
Views: 15,490
Posted By 87hilux7mge
does it have the electronic suspension? if so,...

does it have the electronic suspension? if so, lowering will be more difficult and expensive.

if just standard suspension, you have a few options. you can get lowering springs and struts to...
Forum: MKIII Supra 04-26-2011, 02:37 AM
Replies: 90
Views: 30,056
Posted By 87hilux7mge
thanks canadian, so with that info, it will have...

thanks canadian, so with that info, it will have to be longer. same case then, go to the pick n pull, and find a long driveshafter from a pickup, preferably a full size pickup, with a diesel and in...
Forum: MKIII Supra 04-25-2011, 08:29 AM
Replies: 90
Views: 30,056
Posted By 87hilux7mge
the help has been posted already. the switch...

the help has been posted already. the switch wires that need to be jumped are on the car, part of the wiring harness itself. driveshaft, check the local pick n pull yards, or you may have to pay...
Forum: MKIII Supra 04-24-2011, 08:32 AM
Replies: 2
Views: 5,747
Posted By 87hilux7mge
good news on the injectors then, ill use that...

good news on the injectors then, ill use that flowmatched set of gte's. hes only put about 2k on them, and has all the paperwork from them. traded him a trick fuel rail for them so im not actually...
Forum: MKIII Supra 04-24-2011, 07:11 AM
Replies: 2
Views: 5,747
Posted By 87hilux7mge
High or Low impedance injectors?

aight so i need a lil advice. i have been doing TONS of research on injectors recently, cuz i have a few options for my application.

it will begin as an N/A 7mge, bored .50mm over, balance...
Forum: MKIII Supra 04-24-2011, 05:54 AM
Replies: 25
Views: 8,783
Posted By 87hilux7mge
yea its news to me too. the fact i got two motors...

yea its news to me too. the fact i got two motors with the same pistons is kinda crazy.

but yea, never seen em b4 with a stock motor. then again, out of the 3 ive seen apart, two have had the high...
Forum: MKIII Supra 04-24-2011, 03:24 AM
Replies: 25
Views: 8,783
Posted By 87hilux7mge
yep they are aisin, its cast onto the opposite...

yep they are aisin, its cast onto the opposite inner piston skirt. yea im curious too. ill see what i can dig up, might have to see about calling a few dealerships, or tomoco themselves.

the last...
Forum: MKIII Supra 04-24-2011, 01:55 AM
Replies: 25
Views: 8,783
Posted By 87hilux7mge
hmm. well they spec out at stock bore (83mm...)...

hmm. well they spec out at stock bore (83mm...) so idk how they could be .50mm/.020 over. both sets are stock bore for a 7mge, so now im really confused.

as far as i could find, the crown only...
Forum: MKIII Supra 04-23-2011, 08:08 PM
Replies: 25
Views: 8,783
Posted By 87hilux7mge
so i got one of the pistons yesterday, and the...

so i got one of the pistons yesterday, and the serial number is 42090. theres some in my album, linked below.

http://www.toyota-supra.info/forums/members/23715-albums198.html

hope someone has...
Forum: MKIII Supra 04-23-2011, 07:38 AM
Replies: 4
Views: 6,096
Posted By 87hilux7mge
its been done alot before with good results. as...

its been done alot before with good results. as long as ur gasket doesnt leak right now then it should be good. dont loosen them just tq them down in id say two increments to 75lb ft and live worry...
Forum: MKIII Supra 04-23-2011, 07:32 AM
Replies: 25
Views: 8,783
Posted By 87hilux7mge
my buddy john did that when he sunk his gte...

my buddy john did that when he sunk his gte powered buggy bout a month ago. hydrolocked #6 cylinder and shot the bent rod through the block. quite impressive actually!
Forum: MKIII Supra 04-22-2011, 10:14 PM
Replies: 90
Views: 30,056
Posted By 87hilux7mge
lol, agreed on the tranny removal. ive only dont...

lol, agreed on the tranny removal. ive only dont that on a couple cars, and it was a pain most of the time. the camaro i had i could have the tranny out, new clutch and back in ready to drive in...
Forum: MKIII Supra 04-22-2011, 10:10 PM
Replies: 6
Views: 2,717
Posted By 87hilux7mge
yea agreed. low power flow through the wires or a...

yea agreed. low power flow through the wires or a bad starter switch, dunno if the mk3 has that though, my truck does and its an 87 (why i put a push button in.. :bigthumb:).
Forum: MKIII Supra 04-22-2011, 10:04 PM
Replies: 11
Views: 6,492
Posted By 87hilux7mge
100 bux is spendy damn! 80 bux is the most ive...

100 bux is spendy damn! 80 bux is the most ive ever spent for a warranted alignment. but i guess the dealer is ok. u just want a national shop that will honor their warranty basically.
Forum: MKIII Supra 04-22-2011, 09:28 PM
Replies: 25
Views: 8,783
Posted By 87hilux7mge
piston dish that on the pistons i bought was...

piston dish that on the pistons i bought was exactly as you said cre, 3mm, just under 1/8th inch (if my math is correct...??). i do remember gauging the other pistons and they are just under 1/16th...
Forum: MKIII Supra 04-22-2011, 08:36 AM
Replies: 3
Views: 2,189
Posted By 87hilux7mge
hmm. lemon parts? where did you get em and did...

hmm. lemon parts? where did you get em and did you use thread sealer or teflon tape on all the connections?

ive had soft clutch line hose have an internal hernia, couldnt see it from the outside....
Forum: MKIII Supra 04-22-2011, 08:32 AM
Replies: 90
Views: 30,056
Posted By 87hilux7mge
bleeding the clutch is fairly pain free. first...

bleeding the clutch is fairly pain free. first fill the reservoir with fluid, then (this must be done with a buddy) pump the clutch 2-3 times and hold the peddle down. have someone or urself,...
Forum: MKIII Supra 04-21-2011, 11:50 PM
Replies: 8
Views: 2,753
Posted By 87hilux7mge
:werd:. thats the crappy part. i dumped about...

:werd:. thats the crappy part. i dumped about 8500 into my camaro and with it putting down about 400 hp and a perfect body and decent interior, i only saw 3000....wish ida kept that car.

id say...
Forum: MKIII Supra 04-21-2011, 10:32 PM
Replies: 7
Views: 3,164
Posted By 87hilux7mge
would still say it needs a rebuild. could be a...

would still say it needs a rebuild. could be a water or oil leak and its pumping steam/smoke through the intake tract. the port also needs to be fixed too.

idk if anyone else has an opinion, but...
Forum: MKIII Supra 04-21-2011, 10:24 PM
Replies: 11
Views: 6,492
Posted By 87hilux7mge
yes forgot to mention the alignment. any time you...

yes forgot to mention the alignment. any time you change a suspension component you need to at least have the alignment checked. and do not go to a place that offers just front wheel alignments. you...
Forum: MKIII Supra 04-21-2011, 10:01 PM
Replies: 90
Views: 30,056
Posted By 87hilux7mge
well the shifter looks to be in the proper spot....

well the shifter looks to be in the proper spot. install the shifter and row through the gears, that will tell you if you need to modify the trans tunnel.

the mount, like i said, i cant see...
Forum: MKIII Supra 04-21-2011, 10:00 PM
Replies: 21
Views: 10,919
Posted By 87hilux7mge
well...the clips you show look like a cold start...

well...the clips you show look like a cold start injector clip (red) and a starter connection possibly (blue) :/. the two 7m motors i got had different connections, 1 from an 88 jdm supra and one...
Forum: MKIII Supra 04-21-2011, 09:36 PM
Replies: 90
Views: 30,056
Posted By 87hilux7mge
ok, well id be wary of that transmission mount,...

ok, well id be wary of that transmission mount, but i cant tell if you have a full crossmember or just an ear that bolts to a tranny ear. if thats the case, id be careful. that ear could break under...
Showing results 376 to 400 of 455

 
Forum Jump

All times are GMT. The time now is 08:06 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.

1986



1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88