Home / Toyota Supra Forums

Go Back   Toyota Supra Forums! Join the Supra forum! > Search Forums

Showing results 1 to 15 of 15
Search took 0.00 seconds.
Search: Posts Made By: My88isGREAT
Forum: MKIII Supra 04-11-2011, 05:23 PM
Replies: 17
Views: 4,582
Posted By My88isGREAT
It is totally my fault CRE is grumpy lately, my...

It is totally my fault CRE is grumpy lately, my bad, and I apologize CRE. Some of the K&N (not mk3 supra) kits come with a heat shield to block off the engine bay from the air filter. I have been...
Forum: MKIII Supra 04-11-2011, 05:09 PM
Replies: 16
Views: 3,951
Posted By My88isGREAT
Don't be a smart a$$ or you will get banned Mr....

Don't be a smart a$$ or you will get banned Mr. Green supra!:hand:
Forum: MKIII Supra 04-05-2011, 10:25 PM
Replies: 24
Views: 10,759
Posted By My88isGREAT
:dance:Yes they did! thanks for asking! ...

:dance:Yes they did! thanks for asking! :gotnos:
Forum: MKIII Supra 04-04-2011, 01:56 AM
Replies: 22
Views: 5,586
Posted By My88isGREAT
OK, check this out dude the head is plenty beefy....

OK, check this out dude the head is plenty beefy. But you call this number right here 805-339-2200 and ask them what their head BOLT torque specks are for 7mgte. I even called to double check to...
Forum: MKIII Supra 04-04-2011, 01:41 AM
Replies: 24
Views: 10,759
Posted By My88isGREAT
OK Mr. Smart guy, then how come I have TWO motors...

OK Mr. Smart guy, then how come I have TWO motors and they are EXACTLY the same, the angle on the exhaust is slightly inside, IF I moved it one tooth in either direction it would be totally screwed. ...
Forum: MKIII Supra 04-03-2011, 01:48 PM
Replies: 22
Views: 5,586
Posted By My88isGREAT
Yes CRE, right again, the head bolts were not...

Yes CRE, right again, the head bolts were not torqued good enough causing the head gasket to blow... All I know is I was told that the new OEM head gasket are much better then the original ones and...
Forum: MKIII Supra 04-03-2011, 01:28 PM
Replies: 24
Views: 10,759
Posted By My88isGREAT
CRE, where do you get the info that you use a...

CRE, where do you get the info that you use a dead plug to check timing? How in the hell would you check the timing on a car that is not going to run right or idle with a non-running cylinder,...
Forum: MKIII Supra 03-31-2011, 01:58 AM
Replies: 22
Views: 5,586
Posted By My88isGREAT
Cool, thanks for the link. Sorry thought it was...

Cool, thanks for the link. Sorry thought it was asbestos, I was told the new ones you get OEM are way better (and could hold up possibly to 14psi) then what they come with 20 years ago though. The...
Forum: MKIII Supra 03-31-2011, 01:49 AM
Replies: 24
Views: 10,759
Posted By My88isGREAT
supracabra, did you set the cam position sensor...

supracabra, did you set the cam position sensor back to where it needs to be when the motor is TDC before you installed it? Sounds like something simple that your missing. You don't need to jumper...
Forum: MKIII Supra 03-30-2011, 09:26 PM
Replies: 24
Views: 10,759
Posted By My88isGREAT
I had .020" taken off my head and had absolutely...

I had .020" taken off my head and had absolutely no problem. Did you check the timing? You know it idles at the 10 degree mark and not the 0 degree mark right?
Forum: MKIII Supra 03-30-2011, 09:15 PM
Replies: 22
Views: 5,586
Posted By My88isGREAT
Sounds great only 85k original miles. Don't...

Sounds great only 85k original miles. Don't forget to open the back plastic "doors" in the rear hatch and put your hand down in the rear quarter panels to check for any standing water. I had no...
Forum: MKIII Supra 03-30-2011, 08:18 PM
Replies: 22
Views: 5,586
Posted By My88isGREAT
AHHH the good old Daytona, I love those cars. ...

AHHH the good old Daytona, I love those cars.
Being the car is so old depending on how many miles it has, and what the original owners have done to it is very hard to tell what needs done if its...
Forum: MKIII Supra 03-30-2011, 04:18 PM
Replies: 9
Views: 9,741
Posted By My88isGREAT
:rofl::rofl::rofl::rofl::rofl::rofl::rofl:

:rofl::rofl::rofl::rofl::rofl::rofl::rofl:
Forum: MKIII Supra 03-30-2011, 04:09 PM
Replies: 12
Views: 3,771
Posted By My88isGREAT
Stop looking at the open turbos in the Import...

Stop looking at the open turbos in the Import Tuner mag's thinking these are actual road driven cars... Plus you say there is "so much pluming." Ok, if you have a 7m (assuming you do being a 91...
Forum: MKIII Supra 03-30-2011, 03:41 PM
Replies: 2
Views: 4,598
Posted By My88isGREAT
Hey, to replace the high pressure side power...

Hey, to replace the high pressure side power steering hose, you will need to loosen or take off the two motor mount nuts, and jack up the front of the motor a few inches then you can weave the hose...
Showing results 1 to 15 of 15

 
Forum Jump

All times are GMT. The time now is 01:53 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.

1986



1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87