wondering if sensers are the same on the auto as the manuel?
 

I just bought a jspec motor that was out of an automatic car and put it into my 89 supra turbo which is a manuel and was wondering what sensers I need to change?It starts up and runs but its not right,It cuts out when you try to drive over 1800 rpms.It will idle when its cold but does'nt allways when its warm.:dunno:

do a diagnostic (check in the faq section to see how to do this)

the engine itself is identical... as long as you swapped over your sensors from your engine to this one it should be the same as before

oil pressure sensor is different - jdm to usdm

dam i can't think of any others lol

anyone else care to chime in

I've checked the code and it gives code 51 I replaced the throttle senser with the old one that worked before and cleared the memory and tried it again and still the same and it gives me the same code 51 again.:dunno: