engine harness trouble
 

so a while back i bought a engine wiring harness from mizubo and it doesn't fit. i was told that the harness was from a 89 turbo auto but apparently its not. the problem is that it will not reach to the 6th injector. therefore the connectors for the starter and trans will not reach. im kinda lost on what to do, any help guys?
oh and i've pm'd the guy but he wont respond

Have you seen how much it would cost to get that part of the harness extended, spliced or anything like that? use part of the old one with the new one? Dont no if that will help but you could look into it.

thats what ima try to dy myself. is solder some extensions on. but this is BS, shouldn't all the wiring harnesses be the same length?

what do you mean it wont reach the sixth injector? the clip wont reach or the harness wont reach? is it by a couple inches or a like 2-3 feet? only asking cause im wondering if you got a rhd harness. either way, you can just extend it. just get some stranded 12 or 14 awg wire and some red butt connectors and electrical tape. when i damaged my harness, thats all i did and it worked fine, cant even tell where i spliced it

the harness wont reach by like a foot.. but when i test fitted it everything else looked like it would be able to make the stretch.. i hope it does