1jzgte swap questions
 

I have an 89, and threw a rod in my 7mgte so I got a 1jzgte to swap in. It came with the motor, tranny, ecu, and a few other parts I can't think of right now. Wat other things will I need? Do I need new axels or a new drive shaft? I'm also planning on going to a single turbo set-up, where is the best place to get a kit for that? Also, if I'm mainly going for 20-80mph times wat would be a good turbo for that?- I still want a decent top end, but that is my main target area.

try driftmotion.com

I tryed that site, and it just doesnt make sense to me... Would it be too much trouble for you to copy and paste some of the more important stuff in here please?

well what exactly did your swap come with?

theres more that you need at the top of my head you need 1jz intercooler unless you have aftermarket, 2j throttle cable it you have a pre-89 you need crossmember and round 89+ motor mounts, a lot of 2jz part fits onto the 1jz ill try to post when i think of more things, im still saving up for the swap still not halfway

mines an 89, and i kno i have to lengthen the harness by like 18' but other than that idk, and im goin with an aftermarket FMIC

1jz's dont have a distributor.
it has an ignitor if thats the same thing

what about dumps or front pipe, the fuel lines and power steering lines are all different
(iam not sure about 7m's cause i had a 1g )
u need all the hydrolic lines plus reservoir for the hydrolic fan, or the hydrolic fan itself if u dont have one.
u need a map sensor as well

sorry about that being all over the place..
thats all i can think of at the moment

blake

you can convert the hydro fan for a clutch fan by getting a 2jz water pump

Here's somthing that might save you some money for a while lol http://store.driftmotion.com/product...uct_id_int=401
its a exhaust manifold that is setup for the ct-26 turbo or the stock one that was on your 7mgt, might not get as much power from it as the twins but like i said it might save you some money.