Head gasket repair
 

As alot of you know my head gasket blew a while ago, so finally im going to start to fix it tomorrow. I bought a Cometic Mls head gasket, and some arp head bolts, so hopefully i can have her done before the weekends over :)

Best of luck to you. Any problems and we're here to help :)

Be sure to replace the fuel injector seals with new ones.
PartsPlus
#274531 Fuel Injector Seal Kit
Retail List $6.62
Shop price $3.33

Carquest has them. Bosch kits fit too, As they are Bosch designed injectors.

I was looking at your Sig and is this your jasper motor with 868 Miles that you are replacing the HG?

yes i have a prior thread if you care to check it out. Jasper will not cover the manufacture defect of the headgasket failure and the ring falure in cylenders 5 and 3. I pulled the head off in about 3 hours (damn iv been doing this too long) found out there are scores on cylender bores 5 and 3. I checked it with an inside-mic and i see about .0023 difference from standard bore. I can easily rebore that in the shop. Its only 23 ten-thou so i might even be able to hone that out. Heres my parts list im going to throw together over the next few weeks.

http://img524.imageshack.us/img524/2...nesetupue9.jpg

You'll be glad you got the parts from HPF.

They hot foot those things right the heck over.
I recieved most of my 3 shipments within 2 to 3 days of ordering.

Just remember they are pacific time zone.

Yea iv ordered from them quite a few times. They actually call me once a week to see if i would like to place an order for my supra haha.

Ok i got some pics + some youtube videos of what it looks like now, sorry for poor quality.

http://www.youtube.com/watch?v=uGDRGaGLgI8 VIDEO 1

http://www.youtube.com/watch?v=-BhbuU89qlU VIDEO 2

http://www.youtube.com/watch?v=nwnwPDLn9Yw VIDEO 3

Realisticlly i thought i was taking pics with my pda turns out it was on video mode. :(
--------------------------------------------------------------------------

PICS

http://img96.imageshack.us/img96/6553/image00018bs1.jpg
http://img59.imageshack.us/img59/7113/image00019nh3.jpg
http://img247.imageshack.us/img247/6...ge00020rk7.jpg
http://img507.imageshack.us/img507/5...ge00021iq1.jpg
http://img293.imageshack.us/img293/2...ge00022rr8.jpg

How many Lbs. of torque did you apply to your idle tensioner pulley???

Engine looks good man.

it was a fully assembled long block from jasper. timing belt was already torqed and timed.