|
![]() |
#1 |
12psi boost
Join Date: Feb 2007
Location: Waukegan, IL
Posts: 255
![]() |
![]()
I had bought a JDM turbo motor from ebaymotors and I had paid $990 for it shipped and I did and did not like the motor. They said that they do a compression and leak down test but I think that was BS.
The good about my motor-everything looked new, cylinder head had pretty much no wear, you can tell that it had very low miles, sensors was in good condition. The bad about my motor- motor had a BHG, pitting around the coolant passages and I had to switch some sensors, install the EGR and stuff, switch the throttle body's but over all I did part out my old turbo motor and I made all of my money back+ some more and now im in the process of rebuilding my JDM motor.
__________________
1987 Toyota Supra Turbo-burgundy exterior w/gray interior+1987 Toyota Supra(N/A) light brown top,dark brown bottom w/light brown interior. |
![]() |
![]() |
![]() |
#2 |
12psi boost
Join Date: May 2006
Location: Athens, TX
Posts: 308
![]() |
![]()
I bought mu 1JZ clip from ebay took a while to get here and some other costs that I wasnt told about but it runs awsome. Other problem is the shipping company damaged the intercooler so now I am waiting till the guy gets me a new intercooler. other than that good experience.
__________________
1987 supra NA 5 speed 1JZGTE swap Tokico Illumina 2 and Eibach springs Tokico pillow blocks Suspension Techniques front and rear sway bar HKS super dragger cat-back exhaust plus test pipe Greddy Profec B spec 2 boost controller HKS type 1 turbo timer Supra sport solid steel drive shaft Walboro 255 fuel pump JZA70 Front end mod 18" Volk Racing AV3 18x8.5 front 18x9.5 rear |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Engine Help! | born2drv | MKIII Supra | 9 | 02-01-2011 08:14 PM |
problem seperating engine from manual tranny | Gengus | MKIII Supra | 7 | 01-29-2008 12:10 AM |
Keeping Engine Cool | mrnickleye | Supra FAQ | 0 | 06-04-2005 10:02 PM |