Clutch Master Cylinder Help please!!
 

I was trying to replace this and could not get to the one nut on the left...i tried for quite a while and finally got fed up...how the hell do I get to and remove that nut?....help!!

Clutch Master Cylinder
 

I don't have any tips as of yet - but I'm going to do this same thing within the next week. After looking again - it looks like an extension and the feel of the fingers might be the answer here. I think the real tough part might just be a fat man laying on his back on the floor board trying to play under this dash. Might be a week but will keep you posted.

I will be trying again today I think my best bet will be a 12mm stubby

I used a gearwrench worked great I did mine because it was leaking on my 86.5. Did you think about rebuilding it instead of replacing you just need a small cylinder hone and the kit. The rebuild kit is like 12 dollars thats what I did worked out just fine. But if anything I think the one on my JDM clip might work on a US version car so I got a practically new one.

well finally got it...the 12mm stubby did the trick..

omg those lil nuts are pia. when i did mine, one fell behind the kickboard with the fuses... what a bitch... finally found it with cut up wrists and a magnet... but now i know how to do it and will make the next time easier