06-12-2006, 03:14 PM
|
#5 |
|
Intake
Join Date: May 2005
Posts: 37
 |
honeing
make sure if you put new rings in the motor that you hone the cylinder walls because if you dont do that it will burn oil relly bad i am in the same position i have my whole motor out to it is not to hard just take your time
good luck joe |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| spun bearing | 91 Supra | MKIII Supra | 4 | 10-23-2007 07:58 PM |
| drive shaft hanger bearing | Robes88 | Non-Generation Specific Questions | 4 | 10-15-2006 03:49 AM |
| carrier bearing | gomezmk | MKIII Supra | 12 | 07-11-2006 04:15 PM |
| Center Support Bearing Problem | purplescott | MKIII Supra | 0 | 03-27-2006 10:17 PM |
Threaded Mode