|
![]() |
#1 |
3" Exhaust
Join Date: Apr 2011
Location: columbus
Posts: 151
![]() |
![]()
its leaking onto the carpet and yes i adjusted the pedal play and everything. it was working perfectly and then it started to feel "spongy" and then i looked at it in my engine bay and it was like overflowing out of that but only a little and then leaking a bit onto the carpet. But this morning when i drove it felt fine..lol i had the whole rear end jacked up so idk if it could of maybe flowed forward and overflowed and caused the seal to not hold since there was all the pressure of the fluid?
Last edited by Awyman18; 06-18-2012 at 02:26 PM. |
![]() |
![]() |
![]() |
#2 |
12psi boost
Join Date: Mar 2011
Location: fort myers florida
Posts: 345
![]() |
![]()
ok. when you installed the new cylinder did you bench bleed it, and after adjusting the pedal have some one pump the clutch and you bleed the clutch from the slave. if not maby over time the little air that was trapped plus more air getting into the lines made it over flow( or could be a cloged line) the only reson i could see it leaking into the carpet again is maby you damadged the cylinder durring install, or the pedal wasent 100% dead on and maby you wore out the seals prematurley
__________________
1987 7m-gte R-154, SS braided clutch line, full 3in exshaust,aluminum radiator,full throttle gen 2 whith GM 3 inch mass air flow,13lbs flywheel, and more to come |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
How hard is the clutch master cylinder to replace? | the#1 | MKII Supra | 2 | 05-27-2016 04:32 AM |
Need Help with Replacing Clutch Master Cylinder | xxx609 | MKIII Supra | 7 | 02-01-2012 01:36 AM |
Clutch Master Cylinder question. 1989 Supra. | PFlanagan | MKIII Supra | 4 | 08-07-2008 08:20 PM |
Clutch Master Cylinder Help please!! | ebang | MKIII Supra | 5 | 05-13-2007 05:36 PM |
Maintenance brake and clutch master cylinder fluid | IHateHacks | MKIII Supra | 1 | 04-18-2007 07:15 PM |