7mg rebuild kit ??
 

i found a kit for like 270 for all piston and rings and bearings that sould way to cheap and i dont want something that im going to put in my motor thats not going to last long i just need to fined a rebuild kit

www.jisautoengine.com
that is the web site i found with the kit / what do you think ?

or this web sit i found to www.rpmmachine.com

JIS is where I got my complete gasket set for my rebuild nice set it came with a metal headgasket to

ok sweet so its worth it then ? i would be getting the whole kit the pistons and everything for it

I paid that much just for the felpro head gasket kit I used. I would not mess around with something as important as engine internals. Make sure you are not gettng something made in china.

ok i wont thanks for the tip bro! well i took off the oil filter and there was not any oil in there so maybe its the oil pump. but the wird thing is that i took out the dip stick and there was oil in there

The oil filter is much higher up on the block

so it would not be the oil pump
then ?

No oil at all?

I just changed my oil and filter when I drianed it then change the filter it just had a little bit of oil in it unlike some cars oil comes pouring out the oil filter I guess it drains out And my motor is just rebuild with no leaks and new oil pump

The filter is high on the block and on its side it should drain fairly quick. As long as the filter has oil in it it should be fine.

Unless it's a turbo and it has that 90 degree thing and screws in the bottom

Did not know we where talking about the gte. So in that case you should have more oil in it than you state. What does your oil pressure gage read?

I don't know if it's the ge or gte he never stated I'm just guessing

:confused:What are we talking about ? I am so confused:confused:

I'm not the guy with this problem I was trying to help

ya bro same here there was no oil in there at all like one of you guys had said it must just drain back down in to the block because its located up so high.
i was told that it might be the rod bearings that might be making that really loud knocking noise when it runs ?

well its an 88 non turbo 7mg 24valve 3000,

Mine had the rod bear knock before I rebuild it but it only knocked between 2500-3000 RPMs and it idle great

when i start mine it knocks REALLY loud when it idils and even when you give it gas

Can you post a video? THat would help a lot.

ya i can probily do it tomorrow