Bolt/ Nut specs???
 

hey umm i need some info for some lost bolts/ nuts :s unfortunately didnt keep good track of everything when taking my engine out :( ok the things i need most is the specs on the bolt that hold the starter to the block/transmission area? the ones that go through the bellhousing, i mis placed mine and dont know what to look for when buying at this point and the TSRM doesnt help me in this department, also the nut on the starter that you fasten the hot lead with i have lost, these things would be easy to find out if the starter was easy to get to, and I'd rather not buy and try a bunch of bolts, thanks in advance for any info/charts/etc.. or link to spot in TSRM where it might tell me this info

wow priceless chart CRE, thanks for your response and your information, it is greatly appreciated, I actually called the toyota dealer earlier today and found out the 10mm x 1.25 measurements but they did not have the length.. but i will save this link for future use for sure, thanks again.

i have a bag of bolts from my conversion . i'll look in tomorrow

ok so nut that holds wire onto starter is a 8mm x 1.25 pitch and bolt that holds starter onto bellhousing is 10mm x 1.25 pitch and the length was about 2 inches.