08-01-2009, 08:40 PM
|
#2 |
|
Stock
|
i'm not the only one
what i ended up doing was getting one from o'rielys . you have to put the new bearing in the old housing but if you can weld or know someone who can you only spend about 100 bucks. Hope this helps!
__________________
1985 project 1988 w/1jzte/afic/3" stainless exh
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Car Show To Raise Funds For Autism Center | khooper | Off Topic Forum | 0 | 04-19-2008 05:20 AM |
| drive shaft hanger bearing | Robes88 | Non-Generation Specific Questions | 4 | 10-15-2006 03:49 AM |
| Center Support Bearing Problem | purplescott | MKIII Supra | 0 | 03-27-2006 10:17 PM |
| do luck middle support bar?? stiffin er up | joel w | MKIII Supra | 1 | 11-09-2005 03:07 PM |
Threaded Mode