stumped :(
 

I just recently put a new motor in my 88 turbo supra, the swap went fine and it ran for 2 days afterwards then had a real bad miss, so bad i could not even build up boost with my foot to the floor so i pulled in a parking lot and shut it off. It has not started back up since then about 2 months ago. The wires on my cam sensor are broken on the cam side AND the harness side, so I put them back together the best why i think i can, when i turn the key the motor is turning, im getting spark from my coil packs and i have plenty of fuel, it starts to "cough" but then dies back out, the bottom end is TDC and so is the cam sensor, i have bought a new starter, spark plugs, spark plug wires and a new battery. I am seriously stumped on this one, if anyone has an idea please let me know, also if anyone has a (good) picture of their cam sensor wires that would be very helpful in making sure mine are in the right places.

What method did you use to set TDC ? are you sure piston 1 was at the top stroke ?

Just checked mine, the two wires at the bottom of the plug are very similar in colour due to the yellow fading and the white tuning yellow from age. Looking from the front of the engine bay the red is top left and green top right. Not sure if the US supras have different colour wiring , mine is a UK supra.

Ne = Red
G1 = Green
G- = White
G2 = Yellow

hey
 

thanks a bunch man you have been a big help, unfortunately i already have the wires locations on the cam sensor side, i need the wire harness side, i cant seem to find that online anywhere, sorry it took me so long to respond i dont have internet at my house so i have to go to a friend's place to post shit on here. if u can get me the wire locations of the harness side that would be greatly appreciated.

MK3 TSRM On-Line

Ask and ye shall receive.
All you ask is answered within.

Since you don't have a pc. You want to save it to favorites and try to print the pages you need once you locate them.