05-30-2008, 04:06 PM
|
#11 |
|
12psi boost
Join Date: May 2006
Location: Athens, TX
Posts: 308
 |
Man do like I did and buy a one peice one they are so much easier to put in and take out. Unless you dont have a turbo then you may have a hard time finding one for a W58 and not the R154 like most of them are made for. As for your brakes dragging I would take a look at how everything is set on the rotors themselves. See if when the wheels are in the air if the rotors turn smooth or if they make the grinding noise. You may also need to check your wheel bearings, if they have play in them then it may be grinding when you have weight on them. Mine were like that and it sucks doing them as well but well worht the effort.
__________________
1987 supra NA 5 speed 1JZGTE swap Tokico Illumina 2 and Eibach springs Tokico pillow blocks Suspension Techniques front and rear sway bar HKS super dragger cat-back exhaust plus test pipe Greddy Profec B spec 2 boost controller HKS type 1 turbo timer Supra sport solid steel drive shaft Walboro 255 fuel pump JZA70 Front end mod 18" Volk Racing AV3 18x8.5 front 18x9.5 rear |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crank Shaft Pully Question | kidsusukigsxr | Non-Generation Specific Questions | 1 | 04-15-2011 08:45 PM |
| Brake question | suprabahamut | MKIII Supra | 4 | 08-13-2008 05:32 AM |
| anti-lock brake system abs question | linuxgurupodboy | Non-Generation Specific Questions | 0 | 09-30-2007 03:06 AM |
| question on removing crank shaft | kidsusukigsxr | Non-Generation Specific Questions | 12 | 07-07-2007 03:49 PM |
| brake question | damdog05 | MKIII Supra | 13 | 07-18-2006 04:01 AM |
Threaded Mode