need help quick please
 

well i cleaned my MAF sensor with the appropriate cleaner and after i reasemmbled everything i started my car and the instant i touch my gas now the car stutters and dies instantly same thing everytime

Why did you cleen the MAF?
What was the car doing before you did this?

i cleaned it because it was recommended to so i used the stuff to clean it and now when i touch the gas it shutters and dies

What did you use to clean it with?

well it was some stuff said to clean the sensor in seconds blash blah blah and the thing i cleaned was the sensor right behind the air filter

Maybe you should let it sit till it dry completly.

Or the MAF is probably messed up now.

i think it is messed up now its sat since last night and it still stutters when i touch the gas

make sure its connected, mine i was trying to figure out what was going on with my car and had the same symtom, then i remembered that my MAF was the last thing i worked on. forgot to plug the harness in.

i made sure it was plugged in i tried to drive it today and it drove fine then all of the sudden it lost power and started shaking violently and jerking

sounds like theres a problem in the connection

You didnt unscrew the two phillips screws by the connector did you?

3 screws :P

i unscrewed the whole back thing fro the metal housing when i cleaned it

im talkin about the screws that are on either side of the connector, some people cant figure out how to remove the connector so they unscrew the whole thing and out comes a bunch of wires and it messes it all up

get an air gun with compressed air and carefully blow the sensor with air...be very carefull as too much air pressure will harm it....blow specially in the small oriffice... I did the same thing and it worked great afterwards.....

there is fluid still trapped in the small holes of the sensor.....