http://www.racingdimension.com/index...ROD&ProdID=275
you can get 'em cheaper than this on other sites

it's cheaper here

http://www.intensepower.com/pihecosey.html

this is what i did and the lights point straight when they're open only 2 inches....unscrew the 2 little screws taht hold the lamp in and get 2 3 inch screws with 2 2 1/4 inch plastic tubes that fit around the screws....put the screws in the frame holes and tubes onto the screws ...put some jb weld along the bottom the the lamp and frame and let it dry...then juss screw them in n wa la....thats what i did....ORRRRR you can get gmc fog lamps that are as wide as the supra lamps but are2-3 inches in height n do the same procedure....

does the 87 have this option?

if they were pointing straight up, they wouldnt be sleepy, they would be awake eyes lol... but theres another way they do it in the 240sx that involves 2 switches you install, and you just fuck with them and adjust the lights how you want, like one switch cuts the power to the motors as there going up, so you turn the lights on, and hit the switch on and off and themotor flicks up a little each time... ill ask my boy how to do it in a min after we finish throwing these adjustable control arms and tension rods on his 300z

There is a light wire underneath the dash you cut that and then hook a switch up to it so you can flip the switch when the lights are at the positon you want, but it will shut off the head lights cause the switch will then act like a breaker

Sleeeepers
 

I found them on this site, they're electronic setups, i think they're a little on the pricey side and they're also made in japan. Car Body Kits for Pontiac Mitsubishi Honda Mustang Acura etc

flushmount headlights and sleepy eye conversion
 

ok well i saw alot of ppl on here saying that they dont make sleepy eyes conversion motors or kits for mk3 "lies lies lies" they have them on ebay look up "mk3 sleepy eye kit" its like $27.91 or some shit they have plenty too also there is many other ways to do it. you um idk uncreative!!!! ppl just set your light were you want them and unplug your wire harness for the motors. cap off the live wire and your good to go duhhhh lol mann ppl. well yeah also just to let ppl know there isnt and probably wont be any mass produced flush mount headlight unfortunalely they arent in high demand ne ways go to this website if you wud like to try and make your own they look great but take some work and destruction any who just letting ppl know that sleepy eyes do exist for our cars My Flushmounts and How I Did It - Supra411 Forums

I don't think, they make them.

they do make them
 

ive been trying to tell you all look on ebay thats where they go up at you have to catch them ebay ebay ebay ebay ebay or you can rewire them also is national they go everywhere keep looking they show up all the time you just have to get the words right try all kinds of phrases sleepy eyes lazy eyes controlled headlight all kinds they will cum up just be patient my link before was the wrong one srry i had the link to the guy who had them ll day but lost it so if i see it tho ill put it in here :werd: ok so rewire is easy all you do is position your lights on "two ppl needed " then test the conector wire harness with a test light just to find you wich one moves the light up and down i think its brwn but im not sure so check it a few times isnt hard to figure out how basicly hook up a switch or switches to the wires and run them back to the harness or wire completely seperate up to u and dbasickly cut the up power wen they get to were you want they only go up you only need a one way swich cuz yeah just spin up and back down looks sick wen you just let them bouce up and down in diffrent motion while crusing into meets fucking clean