89 turbo no tunes:(
I need info on replacing the factory amp under the seat in my supra. The factory amp went under water with the rest or the car U boat captan was driving it during a hard rain. Can anyone help with the wiring of the amp thanks.
|
It shouldn't be that big of a deal, as long as you haven't taken the other one out... All you'd have to do is look at where the wires were for the regular one and put them in the new one.. if they are similar that is, If not it's hard to say over the internet... a picture could help quite a bit to.
|
factory amp
the factory amp has about 20 wites going into a multi connector I can't see where they go. any help would be apretiated.
|
Well theres a good chance that if amp is fried if the multi connecter is anywhere close to it, it's also fried. I picture would help very much. :rolleyes2
|
if you dont know what you are doing dont do it.
take it in to an audio place or find a friend that can do it for you |
there has to be a diagram for this,
when i replaced my factory amp off my other car i jus lookd for the speaker wires, now, i dunt think they could have been off you can still use em i took the wires off the factory amp, and jus connected em to the new amp that i got , it might even easier cuz on sum cars the wires has tags one em, or even names on the wires itself like, frontleft, frontright, rearright, rearleft, of sumthing like that , jus be patient with it dont cut anything or dont connect anything unless your 100% sure |
All times are GMT. The time now is 02:36 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.