|
|
#1 |
|
Stock
Join Date: Apr 2010
Location: Montreal
Posts: 5
![]() |
the car seems to have good air/fuel when its idelling, but under load it leans out to around 16. Just installed a new aeromotive FPR, but the car still leans out. Any ideas? fuel pressure is set to 55psi. Help!
|
|
|
|
|
|
#2 |
|
3" Exhaust
Join Date: Apr 2010
Location: sarasota fl
Posts: 194
![]() |
few questions are you turbo? if so what mods do you have done? also what wideband are you getting your numbers from some of them have a adjustment it may be off. but if you are turbo and your going to 16 on a fully functioning uego then DO NOT drive until this is fixed you'll end up causing major damage
__________________
92 miata 7mgte swap forged pistons,studded mhg, 3 inch dp with a glass pack,blowthrough MAF-T,550cc inj, act stage 2 clutch, fmic kit, greddy rs, full wire tuck, rx7 lsd rear with 4.10s. 15psi "ct26-A"??(waiting on dyno #s) if anyone knows whats up with my turbo let me know it has a larger comp wheel nicer machining and 6 dual fins rather than 5? its confusing and keep finding too much contradicting info. would LLLLLOOOOOOOOVVVVVVVEEEEE a compressor map
|
|
|
|
|
|
#3 |
|
Stock
Join Date: Apr 2010
Location: Montreal
Posts: 5
![]() |
7mgte engine. The mods concerning this problem are, walbro 255 fuel pump, 550cc injectors, Aeromotive FPR, Innovate wideband air/fuel meter, and i'm running a mega squirt system. I don't drive the car because i just finished rebuilding the engine. What would be a good fuel pressure to set it at? stock is 47, no?
|
|
|
|
|
|
#4 |
|
Supra Forum Moderator
Join Date: Nov 2009
Location: Green-Ohio
Posts: 1,297
![]() |
you shouldnt be leaning out with 550 injectors. whats the FPR suposto be set for those.. if you have larger injectors and a mega squirt set at stock FP. no wounder your leaning out.. sounds like you need to re-tune your mega squirter tabels
__________________
92 Ma71 7mGTE Auto. SafcII Supra FAQ Supra MKIII FAQ Classified Section guidelines : |
|
|
|
|
|
#5 | |
|
3" Exhaust
Join Date: Apr 2010
Location: sarasota fl
Posts: 194
![]() |
Quote:
__________________
92 miata 7mgte swap forged pistons,studded mhg, 3 inch dp with a glass pack,blowthrough MAF-T,550cc inj, act stage 2 clutch, fmic kit, greddy rs, full wire tuck, rx7 lsd rear with 4.10s. 15psi "ct26-A"??(waiting on dyno #s) if anyone knows whats up with my turbo let me know it has a larger comp wheel nicer machining and 6 dual fins rather than 5? its confusing and keep finding too much contradicting info. would LLLLLOOOOOOOOVVVVVVVEEEEE a compressor map
|
|
|
|
|
|
|
#6 |
|
Stock
Join Date: Apr 2010
Location: Montreal
Posts: 5
![]() |
I'm gonna try to recalibrate the wideband tomorrow morning, we'll see how that works. I'll also up the fuel pressure to just over 55psi.
|
|
|
|
![]() |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lopeing under load | batmmannn | MKIII Supra | 14 | 06-10-2010 06:26 AM |
| vibrations under load | mike_j_2me | MKIII Supra | 3 | 11-16-2007 05:21 PM |
| stalling under load | marxdenning | Non-Generation Specific Questions | 1 | 01-18-2007 09:51 PM |