Forum: MKIII FAQ
06-15-2007, 05:36 PM
|
Replies: 76
Views: 60,992
The 7mge should be the same set as 7mgte, the t...
The 7mge should be the same set as 7mgte, the t means turbo. The head bolts and manifold studs should be the same. You may end up with 4 extra bolt-nut sets for the turbo, but I don't remember those...
|
Forum: MKIII FAQ
06-11-2007, 07:26 PM
|
Replies: 76
Views: 60,992
|
Forum: MKIII FAQ
05-29-2007, 09:05 PM
|
Replies: 76
Views: 60,992
If you are going to clean the head without a...
If you are going to clean the head without a resurface, careful usage of a putty knife or razor blade scraper can do the job, but it is very easy to scratch the aluminum surface. I have on occasion...
|
Forum: MKIII FAQ
05-22-2007, 11:19 PM
|
Replies: 76
Views: 60,992
Warpage
More often the head will warp before the block (I assume it is a 7MGTE or 7MGE with the cast Iron Block and Aluminum Head). Having the head resurfaced is usually a good idea, and not too expensive,...
|
Forum: MKIII FAQ
12-09-2006, 12:35 AM
|
Replies: 76
Views: 60,992
The needle going up and down can be a sign of a...
The needle going up and down can be a sign of a sticky thermostat, or improperly installed thermostat. The installation direction of the thermostat is often counter intuitive, it opens against the...
|